Pivot Plastic Sprinkler

Application

For general agricultural use, medium and high flows, it is designed specially for travelling systems, mainly CENTER PIVOT and LINEAR MOVES. The special conditions of these machines suggest using a kind of sprinklers that differs from those traditionally used on solid sets.

It is also recommended for under-tree irrigation.

Advantages

• Two twin water outlets, both for main nozzles. This eliminates secondary nozzle plugging and provides a higher flow per sprinkler, which means a lower number of sprinklers in use.
• Its 8º water stream angle greatly minimizes the effects of wind when installed on PIVOTS (10 to 14ft high), reducing evaporation and improving uniformity.
• Three different types of water guide vanes to achieve the desired coverage and spray balance according to the available system pressure.

Technical specifications

• Full circle impact sprinkler.
• ¾” M base thread.
• Two main nozzles.
• 8º Nozzle trajectory angle.
• Pressure range: 20-80 PSI.
• Nozzle range: 9/64”-15/64”.
• Acetal resin body and bearing.
• Polyamide fibreglass arm.
• Protection cap against UV radiation.
• Fulcrum pin and springs made of stainless steel.
• Expanded fulcrum,pin upper end diameter for a better fitting into the sprinkler body.
• Color-coded anti abrasive acetal resin nozzles carved in millimeters and inches for a better identification.
• It can be assembled with plastic or brass nozzles.
• Backturn lock between the sprinkler body and the compresion spring.